| Mini Sun Power Saver |
:: Installation
Single-phase (Example: Apartment)
Three-phase (Example: Small Factory)
Plug in one unit of Mini Sun Power Saver into any independent
13Amp wall socket/Power Point (Prefer close to the main
distribution Box/Circuit Breaker)
For monthly electricity consumption from 250 to 1000kWH:
please use Model MS 188.
For monthly electricity consumption from 700 to 2000 kWH:
please use Model MS 388.
(*For consumption below 700kWH monthly, prefer to use
Model MS 188)
13Amp wall socket/Power Point (Prefer close to the main
distribution Box/Circuit Breaker)
For monthly electricity consumption from 250 to 1000kWH:
please use Model MS 188.
For monthly electricity consumption from 700 to 2000 kWH:
please use Model MS 388.
(*For consumption below 700kWH monthly, prefer to use
Model MS 188)
Plug in one unit of Mini Sun Power Saver to each phase(R,Y,B
phase or 1,2,3 phase) for all three phases, total 3 units are
needed. Please refer the installation to a qualified electrician
(To determine the power points of different phases).
For monthly electricity consumption from 750 to 2500kWH:
please apply 1 unit of Model 188 to each phase.
For Monthly electricity consumption from 2000 to 6000kWH:
please apply 1 unit of Model 388 to each phase.
For Monthly electricity consumption from 6000kWH to
18,000kWH, please apply 2 units of Model 388 to each phase.
phase or 1,2,3 phase) for all three phases, total 3 units are
needed. Please refer the installation to a qualified electrician
(To determine the power points of different phases).
For monthly electricity consumption from 750 to 2500kWH:
please apply 1 unit of Model 188 to each phase.
For Monthly electricity consumption from 2000 to 6000kWH:
please apply 1 unit of Model 388 to each phase.
For Monthly electricity consumption from 6000kWH to
18,000kWH, please apply 2 units of Model 388 to each phase.
Precaution
1. Plug this device into a wall socket/power point, not an extension lead or multiple socket.
2. Plug of the power cord should be firmly attached to socket, poor or loose contact must be avoided
when power is switch on.
3. As the device can store electrical charge, wait for 10 seconds after the electrial supply is switch off
before unplugging from socket
1. Plug this device into a wall socket/power point, not an extension lead or multiple socket.
2. Plug of the power cord should be firmly attached to socket, poor or loose contact must be avoided
when power is switch on.
3. As the device can store electrical charge, wait for 10 seconds after the electrial supply is switch off
before unplugging from socket
| Copyright © minisunpower.com 2003 - 2009 All rights reserved Power Saver | How to Save Electricity | Power Saving Devices Range | How to install Power Saving Device | FAQ on our Power Savers Order Now | Testimonial on our Energy Saving Devices | Our Polices on our Energy Saving Device | Energy Saver Resources | Contact us |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
Selling Mini Sun Power Saver Since 2003
